Electric articulated buses on Indian roads soon a reality

Nagpur Municipal Corporation plans a pilot project to run the articulated buses
The first bus was flagged off from the EKA factory in Chakan to Pune
The first bus was flagged off from the EKA factory in Chakan to PuneSupplied image
Published on: 

Articulated buses, which once carried passengers across some Indian cities, are set to make a comeback. This time, they will be in their electric avatar, with EKA Mobility rolling out the latest models from its Chakan plant in Pune on October 30.

If everything goes to plan, the high-capacity articulated buses will ply the Indian roads early next year. The buses have two cars and an articulated joint in the middle, which allows them to bend while negotiating turns and carry more passengers than conventional buses.

Once widely used in cities like Tamil Nadu, Karnataka and Maharashtra, the articulated buses were discontinued following issues related to supply and operations.

The Nagpur Municipal Corporation (NMC) has planned a pilot project to operate these air-conditioned buses and has secured in-principle support from the government for a proposed ₹152-crore project. The project would start with a limited number of buses.

The project envisages 25 articulated 18-metre-long buses powered by a flash-charging system. The NMC plans to deploy them on the city's Ring Road.

The buses come with two cars, each having a seating capacity of 37 passengers, and a combined standing capacity of 75. Powered by Lithium Iron Phosphate batteries, the electric bus has a range of 150 km per charge, with maximum speed limited to 80 kmph. It also has a turning radius of 53 degrees and 15% gradeability.

The new articulated electric bus has two charging modes – ‘flash’ chargers which use side guns, and the optional inverted roof-mounted pantograph. According to Sudhir Mehta, Founder and Chairman of EKA Mobility, the buses and flash chargers were designed, developed and fully made in India at 30% lower cost.

They use overhead flash chargers that deliver 400-600 kW of power at stops, and are also equipped with side-gun charging to enable depot-based charging.

Regulatory hurdles

However, it will take more time for these buses to hit the road. The buses must complete the Automotive Research Association of India (ARAI) homologation process. The flash-charging technology and infrastructure will also need to be certified.

ARAI director Reji Mathai said the flash charging standards are currently being developed. The standards for this form of charging have not yet been notified. The higher upfront costs for flash-charging pose a challenge for operators.

The Ministry of Heavy Industries (MHI) has held meetings with stakeholders and is exploring ways to use such innovative solutions to strengthen clean, efficient and future-ready urban mobility in the country.

The bus will have to address concerns raised by the MHI on passenger safety and operational challenges. Unlike depot-based charging, the overhead charging will happen with passengers on board. There is also the risk of traffic disruption if either the bus or charging system fails.

Market research firm Technavio said that the articulated bus market offers an efficient, high-capacity urban mobility solution to tackle congestion in growing metropolitan areas, but adoption may face hurdles due to the high upfront investment required. Technavio estimates that increasing urbanisation and traffic congestion will drive the articulated bus market forward. Around 43.6% of the articulated buses operating globally are in Europe, Technavio added.